IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
Preview: IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
Preview: IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
Mobile Preview: IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
Mobile Preview: IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll
TOP

IHSS60-36-30-RC 2phase Nema24 Hybrid 3Nm Closed Loop Schrittmotor ModBus RS485 CAN Bus - CANopen Protokoll

ca. 2 Wochen ca. 2 Wochen (Ausland abweichend)
Lagerbestand:
1 Stück
259,00 EUR

inkl. 19% MwSt. zzgl. Versand

Auf den Merkzettel
Beschreibung
Technical characteristics
  • No lost step, accurate positioning
  • Support standard RS-485 bus and CAN bus
  • Support standard Modbus-RTU protocol and CANopen protocol
  • Three control modes with position mode, velocity mode and homing mode
  • Built-in CW, CCW, SW IO input signal with 5V or 24V for the limit and homing reference
  • A BREAK brake signal output signal u RJ45 standard network connection from the slave through the twisted pair cable can be connected
  • The transmission frequency is most supported by 1Mbps, and the transmission distance is the farthest up to 1KM u 100% rated torque drive motor
  • Variable current control technology, high current efficiency
  • Small vibration and smooth running at low speed
  • Built-in acceleration and deceleration control to improve start and stop smoothness
  • Users can define their own subdivisions
  • Compatible 1000 - wire and 2500 - wire encoders
  • General application parameters do not need to be adjusted
  • Loss phase protection, over current protection, over voltage protection and over position error protection

Bohrungen 50, Schaftlänge 20mm

Anleitung: http://www.cnc-technics.de/IHSS57-RC-manual.pdf
Übersicht der Stepper und Servos: http://www.cnc-technics.de/JMC integrated motor.pdf

 
Kundenrezensionen

Leider sind noch keine Bewertungen vorhanden. Seien Sie der Erste, der das Produkt bewertet.